Make A Two Slope Roof Revit

This is pretty easy to control.

Make a two slope roof revit.

Easier than the previous method. On the properties palette select or clear defines roof slope. If we switch to a 3d view it is far easier to see what is going on. Therefore it would be much better if i could make it one single roof instead.

First activate add split line and draw the lines like below. In sketch mode select a roof boundary line that defines slope indicated by. However i run into some problems when joining walls to the roofs. Activate modify sub elements.

2 modify properties to adjust roof slope. Any ideas on how to do this. In the option bar make sure define slope. Hello i am trying to create a double sloped roof see attached autocad elevation.

Create a roof slope using the defines slope property. I ve tried creating two separate roofs and cutting them to make it look right. You can use any. 8 tips to create sloped roofs in revit 1 check define slope to create a sloped roof.

Click on a roof and change the angle in the slope properties. Click modify create roof footprint tab draw panel slope arrow. To create a gable roof 2 side slope remove slope for half the boundaries. Under constraints for specify.

To specify roof pitch select a slope defining boundary line click the numeric slope definition in the. 3 modify each. On the properties palette select new sketch from the filter list. As soon as you place the point revit resolves the new surface by triangulating it.

You can drag any point in your roof and adjust the roof shape as you want. Create a square footprint sketch and designate all sketch lines as non slope defining. Make sure you place it within the boundary of the floor element. You can envisage that this point may represent a drainage point in our floor that we want to slope down to.

Create a roof slope using slope arrows. This shape editing tools will not appear if you define the roof slope.